Troubleshooting common Canon printer errors
Canon is a very famous Japanese company that manufactures a wide range of imaging devices like cameras, lenses, medical equipment and a few hardware devices like printers. These devices provide high performance and speed. The chances of getting errors on Canon printers are low. But few errors may get the user into printing related problems. Printer errors can be fixed easily. When the error appears, check for possible solutions.
Paper Jam
The paper jam occurs when the paper chunks are stuck on the printer. Users can run into this error when the pages on the input tray are not aligned. The user gives the print command and the roller takes the page. If not aligned, they get stuck inside the printer and then cause the paper jam. Open the printer and clean it. Take out the junk and then close the printer. Now open the document and print your document.
Blank Printing
The printer gives the blank printouts when the cartridge is empty. You have to get a new cartridge for your printer. When you take lots of printouts then go for refilling. Cartridges are costly and if you go for clone cartridges; they may not work properly. Some users reported that Canon printing blank pages when the cartridge was not empty. When the device is not used for months, the ink gets dry. You can either add the solvent or refill new ink on the drum. Open the printer drum and then check the ink. If it is dry then add some solvent and close the lid. Shake the drum until it mixes well. Now take the printout and check for the error.
Unable to recognize the cartridge
Your printer can’t find the cartridge when it is not installed properly. When your printer shows an error; remove the cartridge. Check the sideways and pins of your cartridge. If it is bent then fix it carefully. Also, check for the protective tapes on the cartridges. These are used to prevent mishandling damage. But you have to remove these tapes and clips and then install the cartridge on the printer. Check the pins and remove all the tapes before installing. Many Canon models don’t allow clone cartridges. If you are using a clone cartridge then switch to the original one.
Cannot connect to the network
The Canon printer shows the error when it can’t connect to your network. While making the connection; make sure you have entered the correct password. Close the Wi-Fi on the printer and then wait. Enable the button after 1 minute and search for connection. Select the network and then check for connection. For a wireless connection, place the printer and command device near the access point.
Communication error
Printer communication error occurs due to driver issues. The driver communicates with the printer. When a communication error appears, check for driver updates. Install the latest update for the Canon driver. Sometimes, the driver gets corrupted and can’t install the update. You have to repair those files on the driver. For repair, you can download the repair tool. But when the tool can’t repair the driver then reinstall it. canon pixma mg3000 setup download Remove your corrupted Canon driver and install a new one. The new driver will fix the communication error on the printer.
Memory full
Printer memory is for storing the print jobs. When a user sends a print job, it is stored in printer memory and then prints on paper. You can save several jobs on the memory at once. When you send lots of print jobs, they are stored in a form on the queue. If your printer memory is low then it can store fewer jobs. When the print queue is full and the user is sending jobs then it shows a memory full message. Do not give a new command until it prints the remaining jobs. If you need to print the new job immediately then remove your pending jobs. Now add a new job and take your printout easily.
About Author
